Dually Carabiner Gear Hanging Setup
By HEST Memory Foam Camping Mattress Pads & Pillows | Published: 2026-10-19
Category: How-to Guides
Learn how to use the HEST Dually Carabiner for gear hanging. Step-by-step tips for organizing camp gear, avoiding common mistakes, and maximizing utility.
Quick answer
Use the HEST Dually Carabiner as a compact gear hanging hub: clip one gate to a tent loop or ridgeline, use the other gate to attach items like lanterns, bags, or clothes, keeping your camp floor clear.
Why the Dually Carabiner works for gear hanging
The Dually Carabiner’s dual-gate design lets you clip and unclip from two points without removing the carabiner from either anchor. This makes it faster to swap gear than a standard single-gate carabiner.
Its aluminum body and stainless steel wire gates keep weight low—under half an ounce—so it won’t pull down a ridgeline or weigh on a tent loop. The wire gates also reduce ice buildup in cold weather, though they can be harder to operate with thick gloves.
Limitations to know before hanging gear
The Dually Carabiner is not rated for climbing or load-bearing use. It’s designed for light gear organization (lanterns, stuff sacks, water bottles), not for supporting heavy items like a camp chair or a full backpack. Check your gear weight and keep items under a few pounds.
How to set up the Dually Carabiner for gear hanging
- Choose your anchor point: Attach one gate of the Dually Carabiner to a fixed point: a tent loop, a ridgeline, a backpack strap, or a hammock suspension. Make sure the anchor can support the weight of whatever you hang. Avoid clipping to thin, unsupported webbing that could tear. Check that the gate fully closes and locks (if equipped) before loading.
- Clip your gear to the free gate: Use the opposite gate to attach items like a lantern, a dry bag, or a hat. The dual-gate design lets you add or remove gear without taking the carabiner off the anchor. For multiple items, use the free gate as a master clip and daisy-chain smaller carabiners or loops. Don’t overload the free gate with more than one heavy item; the carabiner is not load-rated. If you need to hang several items, use a separate gear line or a small stuff sack.
- Balance the load and test stability: Before walking away, give the setup a gentle tug to ensure the carabiner stays clipped and the anchor holds. If hanging over a sleeping area, position the gear so it won’t swing into your face or tent wall. Check that the gates are fully closed after each clip. Wire gates can snag on fabric or webbing, so close them deliberately.
Product facts
- Dually Carabiner: The Dually Carabiner is a dual-gate wire carabiner (S-Biner) with two opposing spring-loaded gates made from aluminum and stainless steel wire. You can attach it to one anchor point and still clip/unclip gear from the other gate without removing the carabiner, saving time during setup and breakdown.
Dually Carabiner
